|
| |  | Building Supplies & Heavy Equipment | Home » » » » Shop-Vac 903-28 Replacement Cartridge Filter for Ridgid Wet/Dry Vacuum | | | | | | | Features: | |
• Replacement cartridge filter designed for Rigid and Craftsman wet/dry vacuums
• For wet and dry use
• Replacement filter
• Fits all tanks 6 gallons on up
• Limited Lifetime Warranty
| | | Product Details: | | | Product Length:
| 7.0 inches | | Product Width:
| 7.0 inches | | Product Height:
| 7.0 inches | | Product Weight:
| 1.55 pounds | | Package Length:
| 8.7 inches | | Package Width:
| 6.6 inches | | Package Height:
| 6.5 inches | | Package Weight:
| 1.25 pounds | | Average Customer Rating:
|  based on 14 reviews |
| | | | Customer Reviews: | |
Average Customer Review:
Write an online review and share your thoughts with other customers.
 Fits snug, works greatJul 17, 2010
Sooner or later you're going to need a new filter for your shop vac. Mine is a Rigid, and the filter finally wore out after sucking up tons of water, dust, dirt, leaves, and basically anything that would fit up the hose. Rather than buying a new vac, I went searching around for a new filter, and found this guy. It's cheaper than getting a new vac, though mine is getting a bit old. Anyways, replacing the old filter was a snap. This filter fit like a glove, and my vac is now back in action and ready for more abuse.
Perfect FitJul 11, 2010
I have one of the old 12-gallon Ridgid Wet/Dry Vacs.
This filter fit it like a glove.
It has the holding plate fashioned in. You only need
the plastic screw cap to hold it in place.
4 of 4 found the following review helpful:
Great replacement filter for Craftsman shop-vacFeb 17, 2010
As per an earlier review, I too have a 16 gallon Craftsman shop vac that utilizes a "red-stripe" filter. The vac is about 2 + years old so I was probably due for new filter. Even though the measurements of this replacement filter are slightly different than the Craftsman original filter, this replacement fit just fine, but did require that I use the original cap from the old filter instead of the one provided so it could be secured the the appropriate filter location on the vacuum. No problem - it fit just fine. I am very happy with this product and would definitely buy one again versus paying an outrageous amount to buy one from Sears.
1 of 1 found the following review helpful:
Rigid 16 galJan 11, 2010
I recently inherited a Rigid 16 gallon shop vac that is several years old. The existing filter was a mess and was very "floppy." I was pleased to note that this replacement filter has a wire mesh support cylinder inside. It fit perfectly and works well. Be sure to keep the nut that holds the old filter on, as you'll need to use it with the replacement. Seems like a reasonable price.
2 of 2 found the following review helpful:
Fits Sears Large Wet/Dry VacDec 17, 2009
I have an older Sears Craftsman shop vac. I don't know what the model is because the label fell off, but it is quite big, probably a 25 gallon container. I needed a new filter because the old one was at least 15 years old and falling apart. This one looked like it would fit and 'sho nuff', it does.
| | |
* Estimated shipping rate for US 48 states. Final rate calculated at checkout. |
